Engine Control Cables
These control cables and levers are produced by Aero Control
Enterprises specially for Aero Propulsion Technologies.
Aero Controls' throttle systems are factory installed on many kit
aircraft. Aero Controls' systems have been chosen because of
attention to detail and use of the highest quality materials. This
attention to detail results in an exceptionally smooth, highly
dependable, long lasting throttle assembly.
cable systems utilize a nylon outer housing (5mm), a flat wound
carbon steel casing and a friction refusing nylon inner liner. The
cable is ultra-low friction (1x19) 1.2mm stainless steel. A high
quality silver solder is used to connect the carburetor cable
nipples and oil injection fittings. these solder joints have a 40x
safety factor. All aluminium parts are anodized or powder coated for
corrosion protection and aesthetics.
Aero Controls' throttle
quadrant kits utilize CNC machined guides and side plates. Every
quadrant comes complete with cable adjusters and cockpit adjustable
friction controls. The choke lever (if included) has a lock-out
feature preventing the choke from inadvertently being activated
while in flight.
Throttle and choke cable assemblies can be custom
designed to fit your aircraft. Aero Controls is familiar with
most makes and models of ultralight/light planes on the market.
Cable sets that allow for both foot and cruise throttle operation
are available for flex wing trikes. Aero Controls can manufacture to
your specifications if required.
Everything needed to connect your
throttle cable to your engine and throttle lever is included with
each cable set. Even the Allen wrench needed to tighten the
set-screws is included... the "T"-Clip mounting bracket is free when
you order both the throttle and choke cables assemblies at the same